Multi-Di@g Access J2534 I-2015_v33.06 Installation and diagnose BMW
Multi-Di @ g Access J2534 I-2015_v33.06 is tested Okay and released at www.obd2france.com, to help users learn the details, I write this post on how to install Multi-Di @ g Access J2534 I-2015_v33. 06 and how to use it to BMW diagnosis.
Part 1: Before install, you need to do these:
1) Disable both local area network connection and wireless network connection
2) Install Microsoft. NET Framework 4
Part 2: Install "DAEMON Tools Lite"
Select language, then "Free License" till finished, then pops up "new wizard connection" and window "DAEMON Tools Lite 10.1"
Open folder "Key 099873", click "keyUpdate", then get a window message, click "OK" to agree update your registration component, update successfully for VCI 99873, exit.
Again open "DAEMON Tools Lite 10.1", select "Images" to open "MDO I-2015_v33.06" under software(D:), then click the blue icon "MDO I-2015_v33.06", the next steps will automatically install.
Part 3: Multi-Di@g Office activation code
Come to Multi-Di@g Office activation code. Send the identifier to your supplier to get an activation code.
Select features
Wait for about 30-60 minutes before you complete the software installation.
Part 4: Come to VCI Serial Number
Open folder "I-2015_SPI_33.11", click "setup"
Come to VCI Serial Number; please enter the serial number of your communication interface VCI. Please wait about 30minutes before it complete.
Restart the computer, open folder "I-2015_SP2_33.21", click "Setup" to install one more time.
Part 5: Plug the device to the computer to install driver
Plug the device to the computer, get "Found New Hardware Wizard" then install the driver.
Open C:\ACTIA\Multi-Dia@g\AT530, click "Communication Interface", select "USB-Universal Serial Bus", click "Ok". And then click "VCI Serial number"
Click "BT530", select a car manufacturer
Quit the application.
Click "Computer Management" - "Device Manager", and then find out "PassThru XS USB Driver".
Part 6: Diagnose BMW with I-2015 Multi-Diag office
Click "Multi-Diag" to diagnose, click icon "Multi-Diag", select car make.
Click BMW model - M3 E90/92/93
Select electronic control system - Engine
Select part.
Get message "Your Multi-Diag@ subsription will end within 0 days....", click "Yes"
Connect J2534 interface to the vehicle, then get a window "found new hardware wizard", install "USB PassThru Driver", then check in "Device Manager" to see if you can find "USB PassThru Driver (Multi-instance)".
Go on diagnose BMW..